DISTRONIC PLUS: Warns and Assists The Driver

-

Inadequate following distances, inattentiveness on the part of the driver and unexpected, abrupt traffic standstills are the most common causes of rear-end collisions. Radar-based DISTRONIC PLUS adaptive cruise control provides a remedy here.
   Enlarge
DISTRONIC PLUS
The system keeps you automatically at a distance from the vehicle in front and makes a major contribution towards minimising the risk of rear-end collisions by identifying potentially dangerous situations and responding accordingly.
DISTRONIC PLUS: Radar-based assistance systems can prevent 20 percent of all head-to-tail crashes
   Enlarge
   Enlarge
DISTRONIC PLUS
The cutting-edge radar technology employed by DISTRONIC PLUS monitors the situation ahead of the car and is able to recognise an impending accident. Behind the front bumper panels there are two short-range radar sensors covering a range from 20 cm to 30 metres and a scanning angle of 80 degrees. The long-range radar is concealed behind the radiator grille. A special drum technology enables both long- and mid-range coverage. The system has a long-distance range of 200 m at a scanning angle of 18° and a mid-distance range of 60 m at a scanning angle of 60°.
   Enlarge
The DISTRONIC PLUS proximity control has an operating range of 0.2 to 150 metres and is capable of braking the car all the way to a standstill and accelerating it back up to the pre-set desired speed, if the traffic situation permits.
DISTRONIC PLUS brakes the vehicle automatically in stop-and-go traffic, bringing it to a standstill if necessary. Automatic braking is carried out at a deceleration rate of up to 4 m/sec2. As soon as the traffic situation allows, DISTRONIC PLUS accelerates up to the set speed again, relieving the driver of tiring routine activities involving repeated moving off and subsequent braking in stop-and-go or bumper-to-bumper traffic.
If DISTRONIC PLUS detects that heavier braking is necessary, an intermittent warning tone will sound and a warning symbol will light up in the instrument cluster. These two warnings prompt the driver to exercise special caution and to apply the brakes himself, if necessary. To move off again after coming to a complete standstill, the cruise control lever must be lifted or the accelerator pedal tapped.
The speed set by the driver is shown on the display when DISTRONIC PLUS is active. When a relevant vehicle is recognised in the radar detection range, its speed is also shown on the display. A distance display can also be called up.

Commentaires

Enregistrer un commentaire

Posts les plus consultés de ce blog

Automatic Transmission - 6-Speed PowerShift Transmission - MPS6/6DCT450 - Diagnostic Strategy

-
Image
Diagnosis and Testing Refer to Wiring Diagrams Section 307-01, for schematic and connector information. General Equipment  diagnostic equipment Inspection and Verification Verify the customer concern. Visually inspect for obvious signs of mechanical or electrical damage. Visual Inspection Mechanical Electrical Fluid level too high/low Poor condition of fluid Fluid leak Damaged shift mechanism/linkages Damaged automatic transmission/ transaxle casing Fuse(s) Relay(s) Wiring harness Electrical connector(s) Selector lever module Transmission control module (TCM) If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step If the cause is not visually evident, verify the symptom and refer to the Ford diagnostic equipment to diagnose the system. Diagnostic Trouble Code (DTC) Chart NOTE: The following table should be used for guidance
Lire la suite

Electronic Engine Controls - 1.6L EcoBoost (118kW/160PS)

-
Image
Description and Operation Front view of engine Item Description 1 Variable camshaft timing oil control solenoid, exhaust camshaft 2 Ignition coil-on-plugs 3 CMP  (camshaft position)  Sensor - intake camshaft 4 Bypass solenoid valve 5 KS  (knock sensor)  sensor – cylinders 3 and 4 6 Electric throttle plate position sensors 7 Oil pressure switch 8 Shut-off solenoid valve 9 Electrically heated thermostat 10 KS  sensor – cylinders 1 and 2 11 The  MAP  (manifold absolute pressure)  sensor 12 Variable camshaft timing oil control solenoid, intake camshaft 13 Fuel pressure sensor – high-pressure circuit Rear view of engine Item Description 1 CMP  Sensor - exhaust camshaft 2 Fuel Metering Valve Comments: Part of the high-pressure fuel pump 3 Two-point  HO2S  (heated oxygen sensor) 4 Broadband  HO2S 5 The  ECT  (engine coola
Lire la suite

Diagnostic et essais Allumage automatique des phares

-
Image
Eclairage extérieur - Allumage automatique des phares Diagnostic et essais Se reporter au chapitre 417-01, du Manuel des schémas électriques pour les schémas et les informations sur les connecteurs. Outils spéciaux / Equipement d'atelier et outillage standard Kit de testeurs de bornes 29-011A Multimètre digital. Outil de diagnostic. Contrôle et vérification Note : Le module électronique générique (GEM) fait partie du boîtier électrique central (CJB). Note : Si le module GEM est remplacé, le module neuf doit être configuré après la pose. A cet effet, les données spécifiques au véhicule sont extraites du module à remplacer à l'aide de l'équipement de diagnostic et sont transférées dans le module neuf. Note : Avant d'extraire les données spécifiques au véhicule, s'assurer que toutes les connexions électriques du véhicule sont de nouveaux raccordées, de sorte que le module et l'outil de diagnostic puissent communiquer correct
Lire la suite