FORD C-MAX Front Suspension


Note: The notched ring with ABS ( antilock braking system ) is integrated into the wheel hub . Improper installation of wheel hub leads to a malfunction of the ABS .
The suspension of the front consists of two McPherson struts and two lower L -shaped arm fixed to the axle body to the front axle by means of two rings without maintenance.
The suspension arms are made :
Steel on early models of C- MAX and Grand C -MAX ( with the exception of diesel 1.6L Duratorq - TDCi ( DV ) ) ,aluminum on the C -MAX alloy diesel 1.6L Duratorq - TDCi ( DV ) engine.Subsequently, the C- MAX and Grand C -MAX will be no longer produced with suspension arms made ​​of aluminum.
Note: It is not possible, maintenance, replace the ball joint separately arm (steel or aluminum ) . In maintenance , the complete suspension arm must be replaced .
Care must be taken to correct the position of mounting the suspension turret . To ensure proper alignment of the suspension turret mounts , springs and piston rods , the spring plates and supports suspension turret include orientation marks .
Fixing of the suspension arm and the stabilizer bar

 





Rep  -DésignationA - Fixation the suspension arm and the stabilizer bar (top view )B- Fixation the suspension arm and the stabilizer bar ( bottom view )1 - Bras suspensionFixing 2Ecrous3  -Barre stabilizerFixing 
4  -BoulonsThe stabilizer bar is mounted with the connection of the lower suspension arm on the front axle beam , by means of two screws.
Compression struts
Depending on the engine, the vehicle can be equipped with compression links .
The compression rods are designed to keep the forces at low values ​​in an accident and thereby ensure maximum safety for passengers .

The need for compression rods depends on the weight of the engine. This means for the C- MAX 2010.75 :
With the exception of the 1.6L Duratec -16V Ti -VCT (Sigma ), the vehicle is always equipped with compression rods .dynamic dampers

 





Rep  -Désignation1   -Contrepoids2   -Liaison rubber3   -Plaque holding the wire harness of the wheel speed sensorThe suspension element resonates because of the rolling noise of tires on the road . This resonance can be seen as a rumbling noise in the cockpit.
The dynamic damper is mainly constituted by a screw member on the counterweight suspended by means of a rubber binder and movable .
The counterweight absorbs much of the energy of vibration and thus contributes to a reduction in cabin noise .
Note: When installing the dynamic damper , it should be ensured that the metal counterweight does not come into contact with the hanger . Tighten the nut to the specified torque . For removal and installation , follow the instructions of the workshop documentation in force.

Impact of failures
A defective connection causes the rubber member and the counterweight suspension abut against the fixing bolts . Impact sound is clearly heard in the cockpit.

Commentaires

Posts les plus consultés de ce blog

Automatic Transmission - 6-Speed PowerShift Transmission - MPS6/6DCT450 - Diagnostic Strategy

Electronic Engine Controls - 1.6L EcoBoost (118kW/160PS)

Diagnostic et essais Allumage automatique des phares